Visualization of Uniplex Data on PC

• Max. capacity: 150 heating circuits (Uniplex) per PC
• Data exchange between PC and Uniplex cards via serial bus (RS 485)
• Graphical visualization of values, parameters, and alarms
• Data input protected by password, with changes allowed only by authorized operators
• Common setpoint input available for multiple heating circuits
• Selection of operating conditions for each Uniplex card using the operation control key:
  • ON
  • STANDBY
• Printer output of setpoints and actual values for a heating circuit with date and time
• Setpoints for each heating circuit are stored in the PC
• Comparison of setpoints between Uniplex cards and stored values in the PC during:
  • PC restart
  • Start of the data connection between PC and Uniplex card
• If discrepancies occur between PC and Uniplex values, the differences will be displayed for each heating circuit
• Status indication for all heating circuits
• Alarm and error messages for all heating circuits, with printouts only as required
• Alarm reset for each heating circuit via PC
• Interface using ASCII data set to a dBase operation for:
  • Remote setpoints
  • Indication of alarms